Most reacted posts

I'll store some in my back yard for you. ?

Good to see this post. I was considering Seplos mason but will now hold off.

I added my Neey by drilling holes for ballance /sense wires. I mount the new on the outside back of the box for better Bluetooth range.

US stock they charge more for storage and handling. That is what I was told. I think it's nonsense, but what can you do? I paid $690.00 for the Apexium diy box. Maybe I should of looked into EEL more.

I've read post of people drill and tapping holes with a bottoming tap. Andies off grid garage shows a repair as well.

I like the EEL terminal compared to a special terminal that may be hard to find or replace. I guess my concern is from a few negative comments about EEL. So far I haven't heard bad about Apexium. Maybe it's just too new?

I've been a "member" for a long time. I just don't post a ton.

I got 2 Rebel batteries but I'm thinking of grabbing a set of these to compare. I could find a buyer for 1 set.

Not enough to build the solar array I'd like to build. This hobby helps keep the pockets empty

How far south are you. I'm in Klamath.

I've seen a few videos and read a ton of comments but I'm not sure if I should be Apexium or EEL battery boxes? Each one has its pro's and cons. Each has had pos and negative comments. I wonder if I'm missing something that would help me decide.

Some really cool builds.

I converted N.M to inch pounds. 5nm was close to 43 inch pounds. 6nm was 53 or something. Since I went 45 inch pound with my Wheeler fat wrench.

Batteryless option as well?

Do you have a photo?

What did you buy?

I like thoes buss bars.

You're correct. Nice catch. Lol.

My phone is not seeing any Bluetooth signal from the battery. I'm right next to it.

Is item 7 from his list the unknown?

If it was for trickle charge would there be any hardware? I don't see anything except for a red light for solar charging.

Any pictures of the pack and cell? How are you measuring the voltage?

I was thinking of build cells in a 12 volt pack and charging with my rv's progressive dynamics 9160al lithium charger. Any reason not to? Building a 48V bank after the top balance.

Cool to see some resolution.

Thank you. I think I can see the BMS and cells. I've tried making changes to a few parameters and hitting save. Not sure if it really did anything.

The Apexium battery terminals didn't allow me to use the 4/0 (0000) battery cable I had built. I may be able to swap out a positive and negative terminal with the EEL style.

Dang

That's cool.

All this makes it difficult to want to purchase cells.

My motorhome has a small solar panel on the roof. I don't see a solar charge controller or any other hardware. I've looked around all the breaker boxes and looked at wiring. Roof panel is about 12" x 18". I see a single reset able dc circuit breaker. Can someone tell me more about what it is?