TommySr's latest activity

D71, that's one way to characterize it, if real republican's were in office, yes we'd be spending big money on our military, and yes mr...

I can’t disagree Maga should become a party. Republicans are traitors and rino They are really democrats

Delmar, which IMO was a losing mistake for republicans, mr trump was always a democrat, they should have forced him to start his own new...

It really does not matter, this is already decided. Remember 81mil voted for a guy that never left his basement.

fpgt72, or voted against someone else, could happen again. :unsure:

Delmar, while I'm not bot expert, if I google Tommy Mcfuckface this forum shows up. :unsure:

Delmar, or could it be google bots. :unsure:

Never if you want your car to work when it's below freezing. Freezing temperatures. You need a base power source for the vehicle...

ken, to each their own, while you may find biden or mr trump cute, Nikki's legs :love:

I would vote for Biden before her.

D71, don't you know the minimum size air compressor that is needed? (how many gal, PSI)

Delmar, you missed an option WRITE_IN we can repeat the drama's of the past, or make American's new history. (first female president)

THE TRAP – Many people say that Congress is the solution to eliminating the Fourth and superseding Branch of Government, the...

tested on both street and grass, while I still have some ESC tuning to do to run it closed loop, it's time to start looking at repairing...

The more listen to him the more want Trump …. Sounds good to me. No wonder they are terrified. The guy crying is up to be deported...

they are very numerous.

It made it around the block for the first time. :) sensorless is kind of rough at low RPMs but smooths out at higher RPMs I'm sure...

I wanted to see if I could run this motor sensorless but using USB extension cables to reach inside my office didn't work, keep losing...

Batvette, I get it, payback and revenge would be sweet, but IMO not a good governing approach . Batvette, my bad, I don't see...

D71, it did but very slow, the encoder cable is too short so I ran it open loop, but there was a 500rpm max when open loop. right now...