You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
All well - the system was approved by the power company today. Thanks everyone for helping me. I sure educated myself a lot with this...
-
Solved - the half-moon circuit breaker was in the wrong position and provided power to the house directly.
-
That must be the problem - the Association set-up. It currently shows all the correct names but those names are greyed out and I am not...
-
That is the way I have it - GVS on and GFS off with Periodic Transmit Enabled. Still don't see home power on the display = why?
-
I am selling fine so the power goes towards the AC1 and is 0.7 kW in the picture above. But why no power to the house and all lights and...
-
What happened to my display as it will not show the house usage any longer? Anyone knows a quick fix to this - the SCP also do not show...
-
I do not have the question mark so I can't educate myself. The other adjustments are...
-
The ACTIVE POWER CONTROL has the GFS, which I don't know what it means - it is Disabled in my system. The GRID VOLTAGE SUPPORT has the...
-
Under ACTIVE POWER CONTROL I have GFS Enable or Disable. What does GFS stand for and it is Disabled in my system - is that correct?
-
I appreciate all the help I have received here. Thank you all for contributing.
What I learned - the Schneider has 2 firmwares 2.07.00...
-
I just changed to your values and now it seems to work ok = I have a green LED. What is strange is that if will not qualify if the...
-
Almost the same as you... but tighter frequency requirements which should not matter I think.
-
Here is mine now with a dart LED
-
Anyone with a working system (I have XW+6848) please tell me if the green LED on the Inverter showing incoming AC1 is green or not lit...
-
Thank you hwy17 - that helps. Now the system is running ok but only on solar as the green LED which should qualify AC1 is not lit. That...
-
Before I start testing - what are typical values under GRID ENERGY MANAGEMENT for the Anti Islanding Disconnect Under Voltage L1L2 Slow...
-
I had the single phase firmware so I sent out 230 Volt on L1 and burned a few things at home so my wife is mad at me. The furnace...
-
Thank you for your help Mister Sandals as we found it at the same time. I will start tests tomorrow with the new firmware and the good...
-
I got it....
I finally found that the unit has 2 different firmwares called almost the same - one for 230 Volt and a different one for...
-
This forum section
Schneider Insight Firmware 1.18
told me there were problems.
Do you know or someone else know what Inverter firmware...
-
Loading…
-
Loading…
-
Loading…
-
Loading…