chrisgraham
New Member
I recently buyed yed one of LiFePo4 batteries (12V 100ah).
After I added a set of M8-Adapter , I connected the batteries with my charging booster (Voltronic VBCS 30/20/250 Triple) inside my camping van.
Unfortunately I forget to deactivate the "pulser" first time, which is helpful for AGM-batteries.
The first time I realized my mistake was, when I turned of the charger. The voltage immediately dropped from 14,6V to 1,0V.
So I disabled the "pulser" function an set the voltage to 14,2V, like recommended in the manual (reset BMS in case of high voltage)
But unfortunately this doesn't seems to work. I also tried lower and higher voltage parameters (13,9/14,4/14,6V), but nothing worked.
I also notice, that the charging voltage jumps between 13,3V and 14,2V, even when the setting is set to 14,2V???
Do you have any tip/ advice for me, how I can reset the BMS?
Kind regards,
Chrisgraham
After I added a set of M8-Adapter , I connected the batteries with my charging booster (Voltronic VBCS 30/20/250 Triple) inside my camping van.
Unfortunately I forget to deactivate the "pulser" first time, which is helpful for AGM-batteries.
The first time I realized my mistake was, when I turned of the charger. The voltage immediately dropped from 14,6V to 1,0V.
So I disabled the "pulser" function an set the voltage to 14,2V, like recommended in the manual (reset BMS in case of high voltage)
But unfortunately this doesn't seems to work. I also tried lower and higher voltage parameters (13,9/14,4/14,6V), but nothing worked.
I also notice, that the charging voltage jumps between 13,3V and 14,2V, even when the setting is set to 14,2V???
Do you have any tip/ advice for me, how I can reset the BMS?
Kind regards,
Chrisgraham