I have 3 EG4-LL V2 48v (Order #92709) that have been working great.
I just installed 2 EG4-LL-S 48v batteries (Order #119431)
I have been using Solar Assistant and have had no issues. With Solar Assistant connected or not I now get an alarm on the 2 new batteries when I connect RJ45s together.
So current config by dip switch
Battery 2 - EG4-LL-S (V4)
Battery 3 - EG4-LL-S (V4)
Battery 5 - EG4-LL V2
Battery 6 - EG4-LL V2
Battery 7 - EG4-LL V2
If I just have Battery 2 and 3 connected to RJ4 splitter they work fine. As soon as I connect Battery 5, 6, or 7 into the RJ45 splitter both batther 2 and 3 go into alarm mode.
I was thinking I needed to upgrade firmware, but I'm not actually sure what file to use since they all only mention the EG4 18K comms.
Anyone have any suggestions or know what firmware I should use.
I just installed 2 EG4-LL-S 48v batteries (Order #119431)
I have been using Solar Assistant and have had no issues. With Solar Assistant connected or not I now get an alarm on the 2 new batteries when I connect RJ45s together.
So current config by dip switch
Battery 2 - EG4-LL-S (V4)
Battery 3 - EG4-LL-S (V4)
Battery 5 - EG4-LL V2
Battery 6 - EG4-LL V2
Battery 7 - EG4-LL V2
If I just have Battery 2 and 3 connected to RJ4 splitter they work fine. As soon as I connect Battery 5, 6, or 7 into the RJ45 splitter both batther 2 and 3 go into alarm mode.
I was thinking I needed to upgrade firmware, but I'm not actually sure what file to use since they all only mention the EG4 18K comms.
Anyone have any suggestions or know what firmware I should use.