EG4_Jared

I will be sending this to our technical writing team to see if we can have this reviewed.

Feel free to DM your serial number for the inverter and I can take look.

If you could dm me your serial number for the invertor and I can take a look at this for you.

The COM port is currently non-functional. I would recommend contacting the distributor from whom the purchase was made to verify whether...

CHARGING VOLTAGE (BULK/ABSORB) 56.2V (+/- 0.2V) FLOAT 54V (+/- 0.2V) LOW DC CUTOFF 47-44V (Depending on load)

Was this issue resolved?

The Chargeverter would only be able to start and stop based off of voltage and SOC.

I would make sure that the protocol on the battery is set to EG4/LUX for CAN and that the Lithium Brand is set to "0."

It sounds like the batteries are top balancing from the float to bulk voltage points at this time. However, if you would like to send me...

I would inspect the PV run to make sure there isn't a break in the wire and that all connections are secure. However, if you would like...

The 3000ehv has a dynamic bond so you should not have to worry about disabling or enabling it. However, I would recommend having the...

I would recommend not removing the terminal blocks.

You would also need to check the charger source priority to make sure that OSO is not selected for solar only.

I agree with Tim. A chargeverter would most likely be your best option here. However, having an autotransformer may work as well.

Would you mind posting a few pictures of your system connections on thread?

Also, I would check with BMS Tools to see if you can view the battery data this way and even try setting the inverter to a user-defined...

Does the PowerPro battery power on isolated? Also, could you confirm voltage with a multimeter?

The information posted in this thread should be helpful. Make sure that the Lithium Brand on the inverter is also set to "0." If you do...

I just wanted to confirm if this issue was still happening since I am a little late to the thread. If so, could post a few pictures of...

So for everyone to understand what happened, and the great @EG4_Jared can correct my explanation, he effectively reset both inverters to...