fmeili1

Same behavior here, my 2019 5-ton TRANE inrush went down from 162amps to 33amps. When the unit is not running, the soft start has no...

So now i have finished my offgrid system in south germany. its a 12kWp PV - Heckert solar - no shading 42° slope - south west 64x...

Why not just use a 24V charger like NPB-360-24 or a LOP-600-27 That has adjustable voltage of 25.6-28.4V

I would like to thank everyone! Without this DIYSOLARFORUM and your help, suggestions, answers, tips, etc. the project would not have...

This is why they "appear" to be well balanced. You are staying in the flat part of the charging curve. There shouldn't be any delta...

I also monitor very closely the battery situation. All 12 batteries are very close regarding their SOC and voltage. Also, while...

Short update after the first 5 full running days of the system. No issues not even small ones - knock on wood :cool: Still no LED...

I've done a bit math of the today's power parabola and found the following formula for the PV power: f(x)≈−0.386082x^2+9.6551x−46.0318...

After 3 days of operation I will tell you about the first impressions and share some initial diagrams. The average consumption load per...

Here are a few more comments about the short LED dropouts if a huge load kicks in or switched off (only on some of the LED's the effect...

Until now, I'm using a smart home rule to ramp up the RV garage minisplit's if batteries reached 100% SOC to the lowest possible...

I was hoping that you would say something like, "I make the meatballs".

Thanks! Long ago in 1992 I've got my diploma at an university of applied sciences in electrical engineering in Germany. But I've never...

Congrats. Amazing build, very detailed and thank you for sharing.

One interesting observation so far. Today I've noticed some of this usual small LED light "blips" which happens when large loads...

Awesome Now, you can just reep the benefits of your labor.

Here is a screenshot of the situation of this morning without load (I've switched the load on, after inspection was approved) while just...

Thanks! It's a huge relief to have these permits now - I've read a lot of terrible stories about failed inspections...

2nd YEAHHHH... today I've just got the final approval from the local electrical energy provider :) :cool:(y) At 11am I've flipped the...

YEAHHHH... with one day delay, I've just got the final approval from the cities building division :) :cool: (y) Now there is only...