Travis55's latest activity

Alrighty thanks, i'll skip that then. When I run the 4 hots (2 from each inverter for split phase) to my transfer switch, Do they go to...

I need 350A, 48V I believe. Six-5kw EG4 batteries. This is the only thing I've found so far but not sure if it's right...

Okay thanks that makes me feel better, I'll go ahead and grap the cable then

I got it to fit on my 2 lv6548

I have a 20 foot run between my inverter and panel, I'm using two LV6548 inverters for a split phase setup. It looks like that would be...

@OffGridForGood This is how it's set up right now, I just moved into the place last year, and the transfer switch was already...

And Solar Assistant set between the two MPP 6548's - trust me you will be glad you have Solar Assistant to monitor the system, and make...

cable sizes all check out. two 6548's = 13,000W at 48 volts you could draw up to 270A from the ESS, I would put a 300 or 350 A Class T...

Each inverter will draw up to 6500/48 = 135A from the ESS (battery bank) but they add since both tie into the small bus pos and neg. The...

Thanks, here's the updated diagram with those edits if I understood correctly. What about the bonding of neutral/ground on the transfer...

Would that be total between the two inverters? I wasn't sure if that 153 stacks and becomes 306 from both of them drawing for split phase.

Thanks! So instead of the two - 200A class T fuses, I would just need one fuse. Since it's in line on the 4/0 cable right off the...

fuse should go between batteries and the switch. First disconnect after meter should be bonded. I don't see communication in this, but...

I was under the impression that the fuse should be the first stop from the battery. Others will know.

Plan to run this as a backup system for now, will grid tie eventually. The transfer switch is already hooked up but none of the rest is yet.