You can also (usually) just put a bolt with a nut at the top of the slip joint after the shelf is seated so there is no way for it to move back out without removing the bolt first.Shipping was free. Total shipped (including promo code MEMBER10) = $139.53
Edit: instead of just a slip joint into a groove on the Fleximount? Would that matter terribly on the crossbeam considering the amount of weight resting on the shelf itself? I would think the battery weight would keep those slip joints from bouncing or moving.
Would definitely not use that for battery shelf. Look really cheap and probably why they don't even provide a load rating.
So looks like the Dewalt shelves are a good deal then for what you get since those are in fact 2 foot deep.I will say the one thing I am disappointed about is that the listing is a bit deceiving as it says it is 2'x4' but the actual width of each shelf is only 18" which means my battery modules hang off either side.
Yup, no doubt. Wish I would have checked the actual specs before ordering. Not a huge deal for me with my battery modules being used but still would have been nice to have the full 2'Would definitely not use that for battery shelf. Look really cheap and probably why they don't even provide a load rating.
So looks like the Dewalt shelves are a good deal then for what you get since those are in fact 2 foot deep.
Between my friend and I we have over a dozen of these shelves, work fine for us.Would definitely not use that for battery shelf. Look really cheap and probably why they don't even provide a load rating.
So looks like the Dewalt shelves are a good deal then for what you get since those are in fact 2 foot deep.