jassdhali
New Member
Hi,
As title suggests I have assembled a Seplos battery pack with a v3 active balancer.
Just waiting on cable to setup up BMS & a few cables for my Sunsynk 5kW inverter.
I was recommended to use a Neey 4A Active balancer, this was before I realised I had one on the Seplos system
I have assembled the battery pack & all the wiring as required, as to set a baseline, due to the fact that I have never put one together before.
Having the Neey balancer in hand. I wanted to remove the wiring for the Seplos active balancer, but I have a connector lead going from the BMS to the v3 balancer,.
This lead is referred to as the 'dry contact wire' on the instructions.
![1709579268451.png 1709579268451.png](https://diysolarforum.com/data/attachments/200/200003-f48d107f670820794a0dd67321c73183.jpg)
My question is will this have any impact on the BMS if I leave this wire off to isolate the v3 balancer.
I hope this makes some sense
Thanks for your time.
Jass
As title suggests I have assembled a Seplos battery pack with a v3 active balancer.
Just waiting on cable to setup up BMS & a few cables for my Sunsynk 5kW inverter.
I was recommended to use a Neey 4A Active balancer, this was before I realised I had one on the Seplos system
I have assembled the battery pack & all the wiring as required, as to set a baseline, due to the fact that I have never put one together before.
Having the Neey balancer in hand. I wanted to remove the wiring for the Seplos active balancer, but I have a connector lead going from the BMS to the v3 balancer,.
This lead is referred to as the 'dry contact wire' on the instructions.
![1709579268451.png 1709579268451.png](https://diysolarforum.com/data/attachments/200/200003-f48d107f670820794a0dd67321c73183.jpg)
My question is will this have any impact on the BMS if I leave this wire off to isolate the v3 balancer.
I hope this makes some sense
Thanks for your time.
Jass