ChrisSwolls
New Member
Hey all! So, I got my system up and running but definitely have some questions on settings.
I have my Victron 712 BMV setup, just changed the parameters for the 48v system.
Here’s the issues I’ve encountered, hopefully y’all have some input:
1) I need a “customer code” to register for EG monitor, I’ve searched every which way I can and can’t find a code for signaturesolar where I went through to get it.
2) My SOC is definitely off based on voltage. I’ve tried switching back and forth between SOC and VOC to monitor SOC and it’s saying I’m much lower than I actually am.
3) Do you HAVE to use wifi or, is there another monitoring method? I’m looking at adding Solar Assistant here shortly but thus far, I’ve had to switch back and forth between the unit and my actual wifi, more or less making my phone useless when trying to monitor the unit and connect to it. For local connect, I cannot monitor the unit via the app unless I connect to its WiFi and can no longer do anything else with my phone lol.
4) I can’t seem to get my parameters to save when connected locally via the app. I’ll go into settings and set them all up, and then they’re gone again.
I know there’s definitely going to be a learning curve so bear with me lol. The Victron stuff is just a little more intuitive for me.
Thanks!
I have my Victron 712 BMV setup, just changed the parameters for the 48v system.
Here’s the issues I’ve encountered, hopefully y’all have some input:
1) I need a “customer code” to register for EG monitor, I’ve searched every which way I can and can’t find a code for signaturesolar where I went through to get it.
2) My SOC is definitely off based on voltage. I’ve tried switching back and forth between SOC and VOC to monitor SOC and it’s saying I’m much lower than I actually am.
3) Do you HAVE to use wifi or, is there another monitoring method? I’m looking at adding Solar Assistant here shortly but thus far, I’ve had to switch back and forth between the unit and my actual wifi, more or less making my phone useless when trying to monitor the unit and connect to it. For local connect, I cannot monitor the unit via the app unless I connect to its WiFi and can no longer do anything else with my phone lol.
4) I can’t seem to get my parameters to save when connected locally via the app. I’ll go into settings and set them all up, and then they’re gone again.
I know there’s definitely going to be a learning curve so bear with me lol. The Victron stuff is just a little more intuitive for me.
Thanks!