Berseker

HOW DO WE EARTH THE SOROTEC INVERTER?... do you also earth the casing? or just the grid side earth cable?

https://www.18650batterystore.com/products/jk-bms-power-switch

So 30 seconds before wiring this piece of junk into my system I discover it requires two 2" long busbars just to connect it to your...

I swear I have kluged more things in the last 2 weeks for this "DIY" solar project than my entire life up until now. Every day it's...

There's a "silver" version of the JK-BMS which has a place I can bolt my battery negative wire, that I understand. But the black style...

You have too high a charge voltage, use 14.0 or 14.2 volts. Your cells are well balanced. The only time you need to take the cells to...

Let the pack balance first. The battery cannot fully charge it one cell keeps cutting off charging due to over volt. Either let it...

AM assuming the battery manufacturer told you, you can wire the batteries in series??. what bms type is inside?. the avg lithium battery...

So far so good on these ETC cells. All were ~ 3.2V with 3mV delta except for one that was 8mV lower (the highest capacity tested cell...

some cells in yout felicity bank are probablly out of balance. this is 7 months after any update?. felicity has a 5yr no questions asked...

Your batteries are most likely bad. I wrote reviews on here about it. Same thing happened to mine. Opened them up and they are...

Yes, observed this as well..had to replace a damaged bms due to my carelessness..and the replacement bms didn't have the soc % voltage...

Could you clarify the new feature?

Since the trigger voltage is low, a high delta ensures balancing only happens when necessary. User can set 0.01v instead

You have to use a good hand held multimeter, measure the actual voltage on the batt + and - terminals. Then the accurate value can be...

Strange case. Try setting the cell cutoff/lvd voltage to 3v x nos of cells and upper cutoff/hvd to 3.45v x nos of cells on ur inverter...

My jk bms shipped with the temperature leads unplugged. I inadvertently forgot to plug them while building a pack, and just realized it...

Same issue here, how did you resolve this Edit; realized i was logged into the standalone daly balancer, and not the BMS. Corrected...

If I try to change SOC in my Daly BMS I get a settings timed out or input is valid, please reset. If I try to reset it says it’s not...