Jpaction
New Member
EG4 doesn’t have the firmware for the PowerPro battery on their site. Does anyone have the latest firmware version?
Gotcha. So it's just missing the actual update program. The Hex file is there, which is the actual firmware file.Open the zip file and you will not find the executable file or the rds bin file.
I looked into this just now. Same thing for me. I use Chrome though, so it could be their super invasive virus protection software, or there could have been an issue with where we are hosting the file.There should also be a an RS485 bin file
No problem! I have the software from the LL-S. This should work in conjunction with the hex file from the Wall-Power Pro update.Thanks for helping out on the weekend
The older firmware did not run the heater if the battery was not charging, but the latest firmware does allow the battery to self consume now.The 3rd Powerpro delivered in December was still holding above 1 C.
They have different firmware, so updating should help the issue I hope.
Does the powerpro heater only work when the solar is up or can it self consume at night.
We haven't come across this before. But, I'd suggest updating to the latest firmware or rolling back for now while I check in with our battery experts to figure out a fix for you. Also, could you let me know what system you're connecting it to?One of my powerpros went into protect mode, PowerView show battery temp of -100 C, BMS shows 4 C for PCB and Cell temp; what's going on here?