featherlite
Solar Enthusiast
I have a Victron Smart SmartSolar MPPT 100/50.
First below is a screenshot of the Trends tab. Notice that when “Solar Current (A)” is selected, here shown in blue, the scale on the left is in thousands of amps, which is not helpful.
However, a few minutes later, in another screen shot shown next below, the amp scale is in tens, which is helpful.
But then, a few minutes later, the scale reverts back to thousands. I cannot figure out how to control the scale. Does anybody know why this is happening and what I can do to keep the scale in tens rather than thousands?
First below is a screenshot of the Trends tab. Notice that when “Solar Current (A)” is selected, here shown in blue, the scale on the left is in thousands of amps, which is not helpful.
However, a few minutes later, in another screen shot shown next below, the amp scale is in tens, which is helpful.
But then, a few minutes later, the scale reverts back to thousands. I cannot figure out how to control the scale. Does anybody know why this is happening and what I can do to keep the scale in tens rather than thousands?