Robbert

Sorry for the noob question, but by "hardware," in my case that means you want your AiO inverter to start and stop the charging, not the...

Just replaced a JK Bms for a spare one and the SOC is totally not right. I know that because the other one in parralel is pretty...

I use Victron Lynx power in. Not very expensive (you get 2 busbars in one case). It helps you to build a clean installation. Also...

Ideally you would fuse everything, but the SOK does have a circuit breaker that should be able to isolate the unit from the system...

Go to your remote console on Venus os in the pi, go to settings, go to vrm online portal and it will show your portal id. That's what...

Something can always go wrong, especially with high currents. Contacts can fuse, FETs may fail, etc. Personally, I trust a class T fuse...

I run a Class T between each battery and the busbar, shown here with the cover off during assembly. The reason is simple, if there was a...

Thanks for your feedback. I'll start searching for a 2 pole din relay

All ungrounded conductors are supposed to be controlled by a common operator. Which means that you should be using a two pole...

Hi, I would like to isolate my inverter from AC-in, and only allow AC-in if that is neccesary. The reasons why I want this are: 1) the...

This fuse arrived and box said 300A, but when I looked at the body of the fuse it says 200A. Returned When they issue the credit I will...

Thanks for the response. This is exactly what I was looking for basically a pro/con for individual banks or one.

You only have a single wire to cell 4+? I believe there should be little red wire B4 AND little red wire B+.

What you want is fine, but you still might want one shared bank. I had a setup like you described but changed it by paralleling the...

Btw. Pylontech are 15s configs, not 16s. If you are going to buy more batteries do select the same 15s config on the new ones. No matter...

Me too :)

Indeed getting matching fuses is important. I found out the hard way :)

Yes I second the Blue Seas T-Fuse Block and Fuses are very good quality. Make sure to get the correct matching fuse block for the fuse.

I purchased the Blue Sea fuse block with matching fuses. For your reference I added a couple of pictures that show the differences...

Had those as well. They might be perfectly fine. However after comparing these fuses with other class-t fuses, I replaced them. The...