I chatted with her last night, but it is a holiday today. I am negotiating a couple deals and all three went dark last night. I am usually in bed, spend a couple hours going back and forth by text/chat.
Nice. Are those from Amy's or separate purchase?
I am using the dual terminals and they seem to be functioning just fine. I don't know if anyone has checked whether the pieces are copper.
I don't really care whether I have single or double terminals but since you are verifying that the single are copper, I am ordering singles from now on. I suspect the double terminals are brass.
I think your plan to fill in the space will work. I added 2 small extra spacers to mine. And you will be fine without the display if you stick with the JBD.
Not insulated on top. If you threw one off a building it would short.
I'd like to see you carry it to the roof of a building to throw it!
Mine came with a small ground screw on the front panel, down low right side. If stacking I would use some type of rubber between four corners(horse stall mat should work) to keep them from sliding around. I just had her add heat function to the BMS for my mobile packs.
They are from Amy. I said I wanted the new batteries with the pressed copper flexible bus bar connectors like some one on the DIY solar forum recently ordered and she knew exactly what I was talking about. She even sent me this image in the chat to make sure. As for the of the terminal holes for the single vs the double, you should ask her. I do know they had to custom cut the holes for my cases.
Ground the case only. I'd daisy chain from the ground hole on the front cover to the next box. Should not matter if they touch.
VS View attachment 212903
